Volant Yukon XL 1500 - Manual (Page 4)

Closed Box Air Intake System
09-13 GM Truck/SUV 4.8/5.3L/6.0/6.2L
PN 15453/154536
7/16//2014
INS15453 Volant Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: (909) 481.3888 · F: (440) 891‐1868
4
E-Mail: [email protected] www.volant.com
21. Press the Volant duct into the hump hose. (Fig U)
22. Press the Volant duct onto the throttle body. (Fig V)
23. Tighten the #60 clamp holding the duct to the hump hose using a 5/16 socket or nut driver only. (Fig W)
24. Tighten the #72 clamp holding the duct to the throttle body using a 5/16 socket of nut driver only . (Fig X)
25. Press the 3/8 breather hose onto the stem on the Volant air duct. (Fig Y)
26. Remove the protective film and place the Volant lid onto the air box. (Fig Z)
27. Tighten the lid into place using the supplied truss screws with rubber washers. (Fig AA)
28. Remove the MAF sensor screws with a T‐15 torx bit. (Fig BB)
29. Clean any dirt from the o‐ring and place the sensor into the adapter. (Fig CC)
30. Tighten the sensor into place using the supplied 4mm screws. (Fig DD)
31. Reconnect the sensor harness onto the MAF sensor. (Fig EE)
32. Reinstall the factory engine cover. (Fig FF)
33. Place the supplied CARB EO label near the system, this label will be needed to pass a visual smog test. (Fig GG)
34. The install is complete, you can now reinstall the negative battery cable, Check all connections before starting
the vehicle and after 150 and 350 miles of normal driving. (Fig HH)
INSTALLATION PHOTOS ON NEXT PAGE