Vortech 1991-1995 5.2L/5.9L Dakota/Ram - Manual (Page 17)

(–) TERM GROUND
C RANE
cams ®
HI-6TR
CAPACITIVE DISCHARGE IGNITION
WITH AUTO-SEQUENCE REV LIMITER
(+) TERM
V
ACUUM
RESER
VOIR
FRAME RAIL
FRONT OF VEHICLE
(VIEW FROM TOP)
FUSE BOX
PASSENGER SIDE ENGINE COMPARTMENT
12. IGNITION/BOOST CONTROL
A. Mount the ignition box in the engine
compartment onto the flat area near
the fuse box and passenger side
headlight. Use the supplied #10
sheet metal screws to secure. (See
graphic.)
B. Route the heavy black cable to a
clean ground. Route the heavy red
cable to the (+) positive terminal
located on the front side of the under
hood fuse box.
C. Locate the ignition coil plug-in
connector (grey and green wires)
on the vehicle wiring harness near
the original spring tensioner
location. Cut the connector from the
harness leaving 2-3" of wire
remaining on the connector.
D. Extend the wires on the coil
connector using the supplied grey and green wires. Connect
the grey and green extensions to the black and orange
wires from the ignition box. Connect the remaining wires
following the diagram on the following page.
E. Mount the timing retard control knob and the map sensor in
the drivers compartment underneath the dash. The knob
control must be in an accessible position from the drivers seat.
F. Attach one end of the supplied 5/32" vacuum line to the map
sensor. Route the red and blue (or brown) wires along with
the vacuum line through the firewall.
G. Connect vacuum line and wiring harness following graphic
on the next page.
11
NOTE: 1996-1997 models
have a slightly different coil
plug location and do not need
wire extensions.