Voodoo Lab Ground Control(Original Version 2) - Manual (Page 22)

21
D I G I T A L M U S I C C O R P O R A T I O N
•
If the device starts at 0, then choose program 128 by
pressing [1] [2] [8].
When no program is selected, the display will show "--"
instead of a program number.
Using Expression Pedals
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Before using Expression Pedals, you need to enable and
calibrate them from Setup mode.
You specify what each Expression Pedal will control by
pressing [SELECT
∨] until the following display appears with
the desired pedal number:
P1. 064 CTL007
↑ ↑ ↑
Pedal Current Message Type
Value
Message Type
Now you need to choose a MIDI message type. It doesn't
matter which you choose as long as it matches the message
type that your device is set to respond to. The choices are:
• No output: "OFF"
•
Pitch Bend: "PITCHB"
•
Aftertouch: "AFTERT"
•
Continuous Controllers 000 through 120: "CTL007"
To choose the MIDI message type press (or press and hold)
[DATA].
Target Device