Delta 70-200 - Manual (Page 5)

Fig. A
Fig. B
GROUNDED OUTLET BOX
CURRENT
CARRYING
PRONGS
GROUNDING BLADE
IS LONGEST OF THE 3 BLADES
GROUNDED OUTLET BOX
ADAPTER
Use proper extension cords. Make sure your extension
cord is in good condition and is a 3-wire extension cord
which has a 3-prong grounding type plug and a 3-pole
receptacle which will accept the tool’s plug. When using
an extension cord, be sure to use one heavy enough to
carry the current of the saw. An undersized cord will
cause a drop in line voltage, resulting in loss of power
and overheating. Fig. D, shows the correct gauge to use
depending on the cord length. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heav-
ier the cord.
Fig. D
EXTENSION CORDS
RECOMMENDED EXTENSION CORD SIZES FOR USE
WITH STATIONARY ELECTRIC TOOLS
FOREWORD
The Delta Model 70-200 Drill Press provides production capacity drilling and includes; 1 hp single phase 115/230 volt
induction motor, pulleys, belts, 0 - 5/8 capacity chuck, 45 degree tilt table L/R, rack and pinion table raising mechanism
and #3 Morse Taper spindle adaptor. A quick release motor mount makes changing the nine spindle speeds (150, 260,
300, 440, 490, 540, 1150, and 2200 rpm) fast and easy.
5
Fig. C
OPERATING INSTRUCTIONS
GROUNDED OUTLET BOX
GROUNDING BLADE
IS LONGEST OF THE 3 BLADES
CURRENT
CARRYING
PRONGS
GROUNDING
MEANS