Velodyne Optimum Series - Manual (Page 18)

www.velodyne.com 12 - Optimum Series User’s Manual
EQ
This button automatically EQs the subwoofer using a 7-band internal parametric equalizer. To use this feature,
first plug the supplied microphone into the Mic Input jack on the front panel of the subwoofer and place the mic
on its stand and in your preferred listening position. Then, by pressing EQ on the remote, the subwoofer emits
12 “sweep tones” that cover the frequencies between 20 and 150 Hz. After the sweeps are complete, the unit
calculates and saves its EQ settings, then returns to normal operation. In order to avoid accidentally activating
the EQ feature, you will need to hold down the EQ button for 1 to 2 seconds before the EQ sweep tones activate.
NOTE: Each time the EQ feature is utilized, the EQ settings for the Optimum subwoofer are reset. If the
microphone is not plugged in, the Optimum subwoofer will emit two sweep tones then cease the EQ operation.
In this case, the previous EQ settings will be preserved.
PHASE
These buttons allow you to optimize the subwoofer performance for the location and your listening position.
Select the switch position at which you hear the most bass. The setting will be shown in the front panel display
by “PH” followed by the phase setting selected — 0, 90, 180 or 270 degrees.
LIGHT
If you wish, you can deactivate the blue front panel display on your Optimum unit. To do this, press the LIGHT
button on your remote. The display will turn off. It will turn on briefly to reflect any other setting changes while
deactivated. To reactivate the display, press the LIGHT button again.
NIGHT
night mode limits the maximum dynamic output of the subwoofer for later night listening or to be more
considerate of close neighbors. Press the night button to turn the night mode feature on or off. Activation of
night mode causes “n” to appear briefly on the display. When night mode is deactivated, the display shows “n
off” and then returns to normal function.
VOLUME CONTROL
This control allows you to balance the output from the subwoofer to the main speakers in your system. This
control should be set to achieve similar volume level from both the main speakers and subwoofer. when pressing
the volume up or down, the setting is shown in the frontmounted lED display as a number between 00 and 80.
NOTE: The volume can also be adjusted via the buttons on the back panel of the subwoofer. These buttons
have the same effect as pressing the up and down volume buttons on your remote. The unit comes preset from
the factory with the volume set at 30 out of a maximum setting of 80.