Velodyne MiniVee Series - Manual (Page 11)

www.velodyne.com MiniVee User’s Manual - 5
Figure 1. Installation Using LFE Line-Level Inputs
Note: If not using an external crossover, you should use the built-in crossover for optimal performance. When
using a single channel input (such as a surround sound processor’s subwoofer out or LFE), the auto on/off
circuit sensitivity will be affected. When one input channel is used instead of two, the unit will see lower signal
levels present at the inputs. This may cause the unit to turn off when listening at low volume levels. If this
occurs, simply use a “y” adapter (available from most dealers) to allow your processor’s single sub line to be
fed into both l&R inputs. This will make the unit turn on at lower signal levels.