Two Notes Reload - Manual (Page 15)

About the Torpedo Reload
4 The Torpedo Reload’s advanced functions
4.1 RE-ACT™
Attenuators are usually known for the negative impact they have on your tone in cases of heavy at-
tenuation, which is mainly due to the fact that the load presented to the amplifier will vary depending
on the attenuation level. On the contrary, the Reactive-Active technology (RE-ACT™) presents your
amplifier with a consistent speaker’s impedance no matter what level of attenuation you are at, thus
preserving the specific character of your amplifier.
With a choice of 4, 8, or 16 Ohms, your amplifier (up to 150W RMS, 200W peak) will actually see
real speaker impedance, and your tone will remain constant throughout the continuous attenuation
curve.
The attenuated outputs and the loadbox output can be used at the same time, so you can
simultaneously record the dry output from your amplifier’s speaker output and perform a traditional
miking of your cabinet(s). You can plug or unplug the speaker cabinet anytime without worrying
about its impedance with regards to the amplifier’s speaker output impedance, as the two are totally
independent.
Another issue with amplifier attenuation has to do with how our ears perceive the sound. In effect,
the lower the volume of the sound is, the less we hear low and high frequencies. That is because
our hearing is way better at low volumes for the mid frequencies of the voice, for example. The
CONTOUR parameter can be seen as a loudness compensation effect, but it can also be used as a
creative effect. Turn the button to the left (Vintage) and you will get a rich, medium-centered tone
with a lot of presence. Turn CONTOUR to the right (Modern) and you will get more bass and treble, a
V-shaped tone to get those frequencies your ears cannot perceive at low volume. Or simply to get
that ultra-tight metal tone or ultra-warm clean tone you are looking for...
Please note that a minimal attenuation is applied to the input power amplifier signal, whatever the
position of the SPEAKER potentiometer. There is no bypass mode in the Torpedo Reload, meaning the
sound will always be attenuated at the Torpedo Reload SPEAKER output. This attenuation is a function
of several parameters, read more about that in our Specifications section 7.2.4.
4.2 Hi-Z instrument DI
Plug your guitar or bass into the DI input and send that signal to your microphone preamplifier con-
nected to your recorder. If the DI signal is too strong for your preamplifier, you can connect the DI
output to a Line input, by using an XLR-XLR cable or XLR (female) to Jack 6.35mm (1/4”) TRS. At that
stage what you want is clarity and Two Notes preserves your guitar’s tone, as you will certainly want
to re-inject it into your amp through the REPLAY™.
This DI signal is also suitable to feed any kind of amplifier-modeling software that can be followed
by the Torpedo Wall of Sound plug-in.
Please note that here is no hardwired splitter function in the Torpedo Reload. To feed at the
same time your DAW and an amplifier, you will need to send back the signal from the DAW using the
REPLAY™ interface. Please read about the REPLAY™ function to discover this new and very effective
way to record your instrument.
4.3 REPLAY™
One of the most interesting options in studios nowadays: play the guitar one day, and mike the am-
plifier (or many different amps) another. The Torpedo Reload is your re-amplifying device of choice.
Two Notes Audio Engineering Torpedo Reload 15