TracRac IM T-Rac Pro Toolbox Mount - Manual (Page 4)

4 T-Rac ToolBox Mount Kit INSTRUCTION MANUAL TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 508-677-4130
5. Transfer hole locations from the clamps onto the toolbox.
• Measure the distance between clamp mount hole centers (Measurement “A”).
• Measure the width of the toolbox belly (Measurement “B”).
Use the chart on Figure 5 to calculate where to mark the centerlines for your holes.
A minus B = C. Then C divided by 2 = D.
Fi
gu
re 4
. T
oo
lb
ox M
ea
su
re
m
en
ts
Record Measurements Here:
Measurement A: ...............................
Minus
Measurement B: ................................
Equals C: ..............................................
Divide C by 2 to get
Measurement D: ................................
A
B
D
D
Hole centerline
Figure 5. “D” Dimension