TracRac IM CabRac - Manual (Page 6)

6 CabRac INSTRUCTION MANUAL TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4839 * 800-501-1587
1. Measure the inside bed width just behind the cab of your truck and set dimension A to that measurement (Figure 7).
2. Tighten the socket head cap screws located on the bottom of all six bushings using the 7/32" Allen Wrench. Torque
to 138 in/lbs.
3. Install cross bar onto saddle plates of the assembled uprights making sure that the four button head cap screws are
through the saddle plates.
4. Before tightening down the cross bar ensure that it is centered be equaling measurements B (Figure 7).
5. Tighten down the cross bar using a 7/32" Allen Wrench. Torque to 324 in/lbs.
CAUTION: Structural rigidity depends on installation of the cross tubes. Failure to install will result in undesired
performance and void the factory warrenty.
CROSSBAR INSTALLATION
Figure 7.