StorCase Technology FJR100 - Manual (Page 4)

FJR100 User’s Guide - Rev. C00 StorCase Technology, Inc.
3
Rear
SCSI ID Select Switch - Provides SCSI ID selection (Refer to section “Selecting the SCSI ID
Number” for further information).
Cooling Fan - Provides ample chassis ventilation (22.1 CFMs).
SCSI I/O Connector - RhinoJR can be equipped with 50-pin Centronics, 50-pin Microminia-
ture (HD50) , 68-pin High Density, or 68-pin VHDCI (used for Ultra2 and Ultra160) connectors.
Contact StorCase for further ordering information.
Figure 2: FJR100 Rear Panel
Selecting the SCSI ID Number
The RhinoJR SCSI ID selection switch is
located on the rear panel of the chassis
(Refer to INTRODUCTION). Carefully se-
lect the appropriate SCSI ID number for
the installed device as shown. Switch
can be adjusted with either the tip of a
pen or a straightened paper clip. Note
that some switch settings may be invalid
for your interface type. Selecting an in-
valid ID number, or selecting the same num-
ber on different devices may cause un-
predictable results and the computer sys-
tem may not recognize the installed de-
vice.
NOTE: Refer to this section after the
drive installation is complete.