StorCase Technology DS320 - Manual (Page 15)

DS320 User's Guide - Rev. B02 StorCase Technology, Inc.
Installation 7
Installing the Drive into the Bracket
NOTE: Removal of the filler panel(s) is recommended for the installation of the drive(s) into
the drive bracket.
1. Carefully remove filler panel(s) by applying pressure to the tabs with the tip of a flat
blade screwdriver (Figure 6).
Figure 6: Removing the Filler Panel
2. Install the drive(s) into the drive bracket. If installing 3.5" devices into the DS320,
attach the 3.5" adapter brackets (included) to the drives before installing them into
the drive bracket (Figure 7). Drive(s) must be side-mounted to the drive brackets
using the provided #6-32 Phillips screws (Figure 8).
NOTE: Do not fully tighten the screws that fasten removable media devices into the drive
bracket at this point. The screws should be tightened after the drive bezel clearance
has been checked with the chassis bezel.
3. After the drive has been installed into the drive bracket, carefully insert the drive
bracket assembly into the chassis.
NOTE: Make any adjustments necessary to the drive(s) to ensure a good fit between the
drive bezel and the chassis bezel at this point. Tighten screws after necessary
adjustments have been made.
4. Secure the drive/bracket assembly to the chassis with four (4) screws (Figure 9).
Drive Bracket
(2 per Chassis)
Removable
Filler Panel
(1 per Bracket)
Apply Pressure Here to
Release Filler Panel
from Drive Bracket
Apply Pressure Here to
ReleaseFiller Panel
from Drive Bracket
320_6