StorCase Technology DS50 - Manual (Page 17)

10 Installation
Kingston Technology Company DS50 User's Guide - Rev. B00
6. If installing removable media devices, remove the appropriate filler panels from the
DS50. The filler panel(s) may be removed by gently prying with the tip of a flat
blade screwdriver as shown in Figure 8. If installing fixed media device(s), leave
the filler panel(s) in place.
Figure 8: Removing the Filler Panel
Drive Installation
Removal of the drive mounting bracket from the DS50 chassis is required in order to fasten
the drive(s) into the bracket. The entire drive/bracket assembly can then be reinstalled into
the DS50 chassis.
1. Turn the Data Silo over and place it on a soft clean surface, so that the bottom is
facing upward.
2. Loosen but do not remove the three (3) screws that secure the drive mounting
bracket to the Data Silo chassis (Figure 9).
3. Place the Data Silo in an upright position so that it rests on its four rubber feet.
4. Remove the drive mounting bracket from the chassis by sliding it toward the
chassis back panel, then lifting upward (Figure 10).
Front Filler Panel
Front Bezel
0623
To 2mm Device
Connector