StorCase Technology DS50 - Manual (Page 13)

6 Installation
Kingston Technology Company DS50 User's Guide - Rev. B00
DATA SILO INSTALLATION
Installing the Drive(s) into the Data Silo
While performing the steps in this section, work on a soft surface to prevent excessive
shock to the drive(s) being installed. Also refer to the manufacturer's documentation
provided with the drive(s).
A #2 Phillips and a flat blade screwdriver will be required during
this procedure.
Removing the DS50 Cover
WARNING: Remove all power from the Data Silo before removing the cover. The Data
Silo contains NO USER SERVICEABLE PARTS inside the unit.
1. Unplug the Data Silo and verify that all cables have been disconnected.
2. Turn the Data Silo over and place it on a soft clean surface, so that the bottom is
facing upward.
3. Loosen the four (4) screws located on the bottom of the unit (Figure 5).
4. Place the Data Silo in an upright position so that it rests on its four rubber feet.
5. Carefully slide the cover rearward off the chassis.
0
Bezel
Chassis Bottom
Cover
0622
Figure 5: Removing the Cover (1-Bay Shown)