StorCase Technology DE75i-SW - Manual (Page 21)

StorCase Technology, Inc. DE75i-SW User's Guide - Rev. A01
14 Installation
Alignment Tool
SCSI ID
Selection Switch
0564
Figure 10: Unit ID Select Switch Location
WARNING: Unlocking the carrier unit switches DC power OFF to the drive. Since
drives require a short amount of time to spin down, allow at least 15
seconds before pulling the carrier unit out of the receiving frame to
avoid possible damage to the drive.
3. A "u" will be displayed once the drive has completed spin down and is ready to be
removed from the receiving frame. The indicator will return to the SCSI ID number when
the carrier is removed from the receiving frame.
4. Use the alignment tool supplied with the DE75i-SW to select the unit ID number of the
disk drive. Refer to Figure 10 for the location of the unit ID select switch inside the
receiving frame.
WARNING: Selecting an invalid ID number, or selecting the same unit ID number on
different devices may cause unpredictable results and the computer
system may not recognize the installed device(s). If the computer
system can not recognize the boot disk, the computer system may fail
to start-up properly.
5. After selecting an appropriate unit ID number, replace the DE75i-SW carrier in the
receiving frame, and LOCK IT IN PLACE.
6. If the DE75i-SW has been installed into an external expansion chassis, verify that
power is ON to the chassis and that the last device in the SCSI daisy chain is properly
terminated.
7. Reboot the computer system.