StorCase Technology SATA DE75 - Manual (Page 18)

10 Installation
StorCase Technology, Inc. SATA DE75 User's Guide - Rev. A00
Figure 7: Unit ID Select Switch Location
Selecting the Unit ID Number
1. Verify that power is turned ON to the SATA DE75 “universal” receiving frame by
turning on your computer. A number will appear in the unit ID display window if the
carrier is locked in place.
2. Unlock the SATA DE75 drive carrier and remove it from the receiving frame. A "u"
will be displayed initially when the unit is unlocked but will return to a number when
the carrier is removed from the receiving frame.
WARNING: Unlocking the carrier unit switches DC power OFF to the drive. Since
disk drives require a short amount of time to spin down, allow about
15 seconds before pulling the carrier unit out of the receiving frame
to avoid possible damage to the drive.
3. Use the alignment tool supplied with the SATA DE75 to select the ID number of the
disk drive. Refer to Figure 7 for the location of the ID Select Switch inside the
receiving frame. Also refer to Table 1 for the Unit ID Display Hex Reference.
NOTE: The unit ID number display is for ID display purposes only.