Star Headlight & Lantern ULB44 The StarBurst Phantom Undercover - Manual (Page 4)

-3-
CAUTION: Take care to ensure when selecting a screw and drilling the hole that it is
capable of supporting the weight of the light and that it does not penetrate the roof of
the vehicle.
6. Loosen (or remove if necessary) both visor
clips enough that one of the forked brackets
can easily slide under each of them.
7. Slide one forked bracket under each visor
clip and tighten the clip such that it securely
holds each bracket in place.
Mounting (CONT'D)
8. Some vehicles may not have visor clips appropriate for this
application, or may completely lack any visor clips. An alternate
mounting screw hole is provided in the bracket for these
situations. Use an appropriate screw or other suitable fastener to
attach the light to the roof brace under the headliner of the vehicle
or some other appropriate mounting surface.
5. Locate the two visor clips on the
vehicle. The style may vary from
vehicle to vehicle. Some styles use
only one screw each, while others
may have more. Verify that both
visor clips are a minimum of 3” from
the center of the window, and a
maximum of 8” from the center.
10. Check your mount from the outside of the vehicle to ensure the desired angle is
achieved. Stand 20 feet from the vehicle and inspect the light through the window.
Make any final adjustments necessary.
Bend here if
necessary
9. Once the brackets are installed securely
under the visor clips or with a suitable
fastener, check to see that the bottom of
the light is level front-to-back. If it is not
level, remove the light from the visor clips
and carefully bend the forked brackets as
necessary. Reinstall the light and check
again for levelness. Repeat this process
until the light is level.