Star Headlight & Lantern ULB21 Star Split-Phantom Undercover - Manual (Page 3)

-3-
Bend here if
necessary
Forked Bracket Installation Without Visor Clips
Some vehicles may not have visor clips appropriate for
the previously described installation, or your application
may completely lack any visor clips. An alternate mounting
screw hole is provided in the bracket for these situations. This
hole can be used with an appropriate user supplied screw or
other suitable fastener.
1. Locate the roof brace under the headliner of the vehicle or other suitable mounting
surface.
2. Pick an area to mount the brackets (one on each side) that is a minimum of 3” from the
center of your window and a maximum of 8”.
3. Determine an appropriate size screw that it is capable of supporting the weight of the light
and will penetrate the mounting surface securely mounting the brackets.
4. Carefully drill any necessary pilot holes in your roof brace. CAUTION: Take care that
you do not penetrate the roof of the vehicle.
5. Install the screws through each bracket.
6. Check to see that the bottom of the light is level front-to-back. If it is not level, remove the
light from the visor clips and carefully bend the forked brackets as necessary. Reinstall
the light and check again for levelness. Repeat this process until the light is level.
Alternate
Mounting
Hole
7. Check to see that the bottom of the light is
level front-to-back. If it is not level, remove
the light from the visor clips and carefully
bend the forked brackets as necessary.
Reinstall the light and check again for
levelness. Repeat this process until the
light is level.
6. Loosen (or remove if necessary) both visor
clips for the 274-ULB21-U1 or the passenger
side visor clip for the 274-ULB10-U1. They
should be loose enough that one of the forked
brackets can easily slide under each clip, then
tighten the clip such that it securely holds
each bracket in place.