Star Headlight & Lantern 9224 Series - Manual (Page 2)

-1-
Please Note: These instructions are provided as a general guideline only. Some
vehicles may require special mounting, wiring, and/or weather-sealing. This is the
sole responsibility of the installer. Star Headlight & Lantern Co., Inc. assumes no
responsibility for the integrity of the installation for this or any of its products.
Current Flash Rate Total Flash Rate
Model Voltage Draw Light Source Per Side Of Minibar
9200H 12 VDC 8 Amps 50 Watt Halogen Bulb 80FPM 240FPM
9200H-24V 24VDC 4 Amps 50 Watt Halogen Bulb 80FPM 240FPM
9200H-WY 12 VDC 8 Amps 50-Watt Halogen Bulb 160FPM 480FPM
9200H-WY24 24 VDC 4 Amps 50-Watt Halogen Bulb 160FPM 480FPM
9200I 12 VDC 6.5 Amps 35 Watt Incandescent Bulb 80FPM 240FPM
9200S 12-24 VDC 2 Amps 11.25-Joule Strobe Head 64DFPM (128FPM) 512FPM
9200SQ 12-24 VDC 2 Amps 17.5-Joule Strobe Head 42QFPM (168FPM) 672FPM
9200ZQ 12- 24 VDC 1 Amp Two 3.75 –Joule Strobes 65QFPM (260FPM) 10400 FPM
1. IMPORTANT: Please read all of the following instructions before installing your new
warning light. This instruction sheet applies only to the models listed at the top of this
sheet.
2. CAUTION: All of our DC powered warning lights are polarity sensitive. These lights are
polarity protected only if the appropriate fuse is used. All wires connected to the positive
terminal of the battery should be fused at the battery for their rated load. Testing the
light before this fuse is properly installed will void the warranty on the light.
3. Remove the dome from your mini-bar. Take care not to damage the gasket. Place the
light in the exact position it is to be mounted.
4. Using the base as a template, mark four holes on the mounting surface. Take care to
ensure that the base does not move while you are marking each of the four holes.
5. Remove the base and drill a 3/8" hole in the four marked spots.
CAUTION: Take care not to drill through the headliner below.
6. Push the enclosed rubber well nuts through the holes until the bottom side of the wider
lip rests on the surface of the vehicle.
7. For external wiring of your new Star mini-bar skip to Step 8. For internal wiring, proceed
as follows: Remove the headliner from the inside of the vehicle. Draw two diagonal
lines between the well nuts in the opposite corners. Mark the location at which they
cross. Drill a 3/8" hole in the center marked location. Place the light on the surface of
the vehicle, routing the wires through the hole. Align the four other holes with the well
nuts, install the screws, and tighten until snug. Skip to Step 9.
8. For external wiring, place the light on the mounting surface and align the holes with the
well nuts. Install the screws and tighten until snug.
9. Replace the dome on your mini-bar.
10. Connect the corresponding wires for your model
9200S
Red: Power
Black: Ground
Purple: Disconnected for Doubleflash
Ground for Quadflash
9200H and 9200Z
Red: Power
Black: Ground
PERMANENT MOUNT VERSIONS