Star Headlight & Lantern RSK310P Strobe Kit - Manual (Page 4)

-3-
RP310 Series Wiring
Power Plug
The power plug should be included with your power pack and comes complete with an 8-
12” wiring harness. This will be connected to the outlet on your pack labeled PWR.
Connect these wires as follows:
BASIC ON/OFF WIRING:
(This setup is typically used for most “On/Off” applications)
1. The black wire should be connected to a
good chassis ground.
2. The red wire from your power plug should
be connected to +12VDC through your
on/off switch (not included).
3. If you are only operating your power pack
with an On/Off switch, you may run on high
power all the time by hooking the white wire
to the black wire (good chassis ground). If
you wish to run only on low power, cut the
white wire short and tape the end.
-----------If you intend to utilize the High/Low option follow the instructions below-----------
HIGH/LOW WIRING: Make your connections as illustrated below, using the optional
#SP3860-2H switch available from your dealer.
1. The black wire from your
power plug on the pack
should be connected to a
good chassis ground, as
should the black wire from
terminal 3 of SW1 on the
switch panel.
2. The red wire from your power
plug will connect to the red
wire extending from terminal 2
of SW1.
3. The white wire from the
power plug allows utilization
of the High/Low (Day/Night
Mode) option. It will be
connected to the purple wire
from terminal 2 of SW2 on the
switch panel. When the white
wire is connected to ground
through SW2 the pack will
operate under high power.
4. The fused red lead from
terminal 1 of SW1 should be
connected to your
+12 VDC power supply.
5. When properly wired, SW1 will be on the left side (Front View) and switch the pack on
and off. SW2 will be located on the right side of the switch panel and will be used to
select between low or high power.
.
(Connect to Ground for High Power)
POWER PLUG
FOR RP310
PWR
CONNECTOR
Red = Power
Black = Ground
White = HI/LO Option
3
1
2
SW1
OFF
ON
SP3860-2H SWITCH PANEL (REAR VIEW)
w/RP310 SERIES POWER PLUG
LOW
SW2
HIGH
2
1
3
CONNECT TO +12 VDC
10 AMP
FUSE
GOOD
CHASSIS
GROUND
BLACK
PLUGS
INTO
POWER
PAK
POWER
CONNECTOR
GOOD
CHASSIS
GROUND
RED
PURPLE
RED
WHITE
BLACK