Star Headlight & Lantern Hide-A-STA Remote Flashing LED Kits - Manual (Page 6)

-4-
The LDF300 flasher unit has twenty different
Flash Patterns to select from.
(see chart to right)
These patterns include:
• 11 different alternating patterns (the
two heads flash back and forth)
•
4 different simultaneous patterns in
each of 2 phases (the two heads flash
at the same time)
• A Cycle All pattern (continuously cycles
through patterns 1-19)
Head 2
2 Complete flash cycles
Phase 2
Cycle 2
Phase 2
TIME
Phase 1
Head 1
Cycle 1
Phase 1
Head 1
2 Complete flash cycles
(ON) (OFF)
Head 2
Pattern Programming
Programming Procedure:
1. If you are NOT synchronizing your
LDF300 with another LDF300 or
approved light, tape the WHITE wire off
so that it does not come into contact with
anything.
2. The GREEN wire is used to program
the desired flash pattern. After the
BLACK and RED wires are
connected (see previous page), you
may set the flash pattern. The LDF300
flasher is programmed at the factory for
Pattern 6 (Pattern Type F – Alternating
Quadflash). To change the pattern,
proceed below:
•
Touch and hold the green wire to
ground until the light blinks once
(approximately 3 seconds), then
release it. This will reset the
light to Pattern 1 (Pattern Type K
– Alternating Flicker).
•
Touch the green wire to ground
for approximately 1 second and
release it to cycle through
Patterns 1-20 shown to the right.
After Pattern 20, the light will
cycle back to Pattern 1.
1 K Alternating Flicker † 1.0
2 L Alternating Fast Doubleflash 3.3
3 M Alternating Tripleflash 2.5
4 N Alternating PSU Flicker 0.7
5 O Alternating PSU Random 0.6
6 F Alternating Quadflash †† 1.0
7 G Alt. Quadflash w/Post -Pop 1.0
8 H Alternating Singleflash 1.0
9 I Alternating Doubleflash 1.0
10 J Alternating Variable 0.3
11 P Alternating Quintflash ††† 1.2
12 K Simultaneous Flicker (Phase 1) 1.0
13 K Simultaneous Flicker (Phase 2) 1.0
14 I Sim. Doubleflash (Phase 1) 1.0
15 I Sim. Doubleflash (Phase 2) 1.0
16 G
Simultaneous Quadflash
w/Post -Pop (Phase 1)
††††
1.0
17 G
Simultaneous Quadflash
w/Post -Pop (Phase 2)
1.0
18 F Simultaneous Quadflash (Phase 1) 1.0
19 F Simultaneous Quadflash (Phase 2) 1.0
20 NONE Cycle All N/A
† = Programming Shortcuts 1, 2, 3, and 4 (see table below)
Pattern #
Pattern
Type
Pattern Description CPS
Programming Shortcuts
Touch the Green Wire to Ground For: Unit Blinks Jumps To
3 seconds 1 time Pattern 1
6 seconds 2 times Pattern 6
9 seconds 3 times Pattern 11
12 seconds 4 times Pattern 16