Star Headlight & Lantern 6464LED-48 " M-Tech PLUS LED Lightbar - Manual (Page 4)

-1-
QUICK-INSTALL WIRING GUIDE
11-Wire Harness
(271-PHANTOM)
Green w/Yellow Not Used or Optional Component
White w/Brown Not Used or Optional Component
Brown Rear Enable (Turns on Rear Facing M-Tech Plus™ Lights)
Orange Front Enable (Turns on Front Facing M-Tech Plus™ Lights)
White Synchronization (Used to synchronize two or more lights together)
Green
Passenger Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
Purple High/Low Select (Optional - Ground for low intensity)
Red w/Green
Driver Side Pattern Select (Touch and release to +12-24 VDC to change
patterns)
Red Power (Connect to constant +12-24 VDC † )
Black Ground (Connect to the negative side of the battery)
Bare Ground (Shield - Connect to a good chassis ground)
20-Wire Harness Wiring (271RAZOR)
Blue Driver Side Alley Light (Switched +12VDC Only)
White w/Blue ICL Power (Intersection Clearing Lights)
White w/Yellow Front Corner (Controls any lights in the front corners other than ICL)
Orange w/Yellow Front Enable (Turns on Front Facing M-Tech Plus™ Lights)
Brown w/Yellow Not Used or Optional Component
Red Power (Connect to constant +12-24 VDC † )
Red w/Green
Passenger Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
Purple Optional - High/Low (Ground for low intensity)
Green w/Yellow Front Center (Controls any lights in the front centers)
Red/Black
Driver Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
White w/Brown Alt. Front Center (Controls any alternate lights in the front centers)
Green w/Red Rear Center (Controls any lights in the rear centers)
Brown w/Red Not Used or Optional Component
Orange w/Red Rear Enable (Turns on Rear Facing M-Tech Plus™ Lights)
White w/Red Synchronization (Used to synchronize two or more lights together)
Yellow w/Black Alt. LED 1 (Controls any alternate LED lights)
White w/Black Alt. LED 2 (Controls any additional alternate LED lights)
Gray Passenger Alley (Switched +12VDC Only)
Black Ground (Connect to the negative side of the battery)
Bare Ground (Shield - Connect to a good chassis ground)
† - The Red wire MUST be connected to +12VDC for the front and rear warning LEDs to operate. If you
are NOT utilizing a separate Front and Rear enable function, you may connect the Red wire, along with
the Front enable wire and Rear Enable wire to +12-24VDC through your On/Off switch.
If you ARE using a separate Front and Rear Enable function, connect this wire to constant +12-24VDC.
Please note: When the red POWER wire is connected to constant power the light will draw a small
current (20 mA). If your vehicle will be sitting for extended periods of time (i.e. more than a few days), it
is recommended all power wires be routed through an ignition switched power source.
WIRE COLORS AND FUNCTIONS WILL VARY FROM HARNESS TO
HARNESS. PLEASE BE SURE TO CORRECTLY IDENTIFY YOUR
HARNESS AND USE THE CORRESPONDING TABLE. IN ADDITION, ALL
LIGHTBARS ARE SHIPPED WITH A WORKSHEET THAT IDENTIFIES THE
FUNCTION FOR EACH WIRE COLOR IN THAT SPECIFIC LIGHTBAR.
!