Installation guide, 4 installing the unit, Tips – Sanuvox S300 FX-GX User Manual
Page 9

PAGE 9
Step 3: Mount Hepa
Step 3: (Continued)
Figure 2.3b -
Unfold the ducting flairs to
sandwich the return air plenum between
the ducting flair and the filtration unit.
Figure2.3a -
Align unit into place.
Figure 2.3c -
Install unit using all supplied
fastening hardware.
Step 4: Finishing
Tips
to installer
It is recommended that the filtration unit
have a devoted receptacle with 115V. It is
not recommended to connect unit with an
extension cord. If no receptacle is available
please call an electrical contractor to have
one installed.
MAKE SURE TO INSTALL
FILTER ACCORDING TO
AIR FLOW DIRECTION FOR MAXI-
MUM PERFORMANCE
Check for this symbol on each
filters and it is located on the
unit’s motor plate.
Figure 2.4b
- Replace door and insert
power cord into the receptacle of the HEPA
and the other end into a wall outlet.
Stage 1: Pre-Filter
Stage 2: HEPA Filter
Figure 2.4a -
Remove protective plastic
covers from all filters and install in their
proper location.
2.4 Installing the unit
(Continued)
Installation
GUIDE