beautypg.com

Recording loud or plosive sounds – Royer Labs R-122 User Manual

Page 12

background image

Choirs and Orchestras can be picked up well with two R-122s. Place the microphones at a
height of ten feet or so and a few feet behind the conductor. The microphones should be spaced
apart approximately one foot and angled, one toward the left and one toward the right.

Drums and Percussion instruments sound full-bodied and natural when recorded with a pair of
R-122s. For a drum set, placing the microphone(s) at a distance of four to six feet above the kit
works very well without making the cymbals sound splattered. A kick drum should be miked at a
distance of at least 18 inches and possibly used in conjunction with a blast filter to prevent
excessive ribbon movement. If the front head has a hole cut in it, position the microphone away
from the hole to avoid excessive air blasts. An R-122 used as a mono room mic, four to six feet
in front of the kit and compressed, will yield a surprisingly large, full drum sound.

For closer miking of a kick drum (10 to 18 inches), the microphone should be leaned forward at
a 45-degree angle to protect the ribbon element from excessive plosive forces (See Example 3).
This microphone position also provides good kick drum isolation because the top of the
microphone, which does not pick up sound, is aimed at the rest of drum kit.

Recording Loud or Plosive Sounds

With all ribbon microphones, wind is the enemy! Air movement is far more damaging to ribbon
microphones than high SPL’s. Some sound sources can generate powerful blasts of air that
should be avoided. Kick drums and electric guitar and bass amplifiers are typical examples of
sound sources that can produce harmful air currents. One way to determine if the air pressure is
excessive is to place your hand in front of the sound source (the kick drum, the guitar cab, etc.)
and see if you can feel actual air movement. If you feel air movement, do not put your ribbon
microphone there. A simple technique that can avert damage due to overstressing the ribbon is as
follows: After choosing the optimum placement for the microphone, slightly angle the
microphone in such a way that the percussive wave is not directed at the front of the mic “head
on.” Often, a slight angular tilt (either vertically or horizontally) is all that is required to prevent
harm to the ribbon.

1. Example of the Vertical Positioning Technique

Slight off-axis positioning will minimize stressing the ribbon on loud sound sources.

12

This manual is related to the following products: