RAVE Sports Performance 3 Piece Aluminum SUP Paddle - Manual (Page 4)

Introduction
At RAVE SUP we live & breathe stand up paddle boarding. We’re all about creating quality
constructed SUP boards, paddles, and accessories that embrace the SUP lifestyle.
Set Up
RAVE SUP boards include a removable fin, cargo net and self-venting pressure relief valve.
It is important to understand how to properly install and remove these parts to prevent
damage to the equipment.
Self-Venting Plug
1. RAVE SUP boards come with a self-venting plug installed.
The vent plug allows the board to regulate pressure inside
the board due to changing temperatures. CAUTION: Keep
board away from prolonged exposure to direct sunlight
or extreme heat when not in use in order to prevent
potential damage to the deck pad and other surfaces.
2. Upon first use, be sure to check that the vent plug is tight.
Tighten using a quarter or a large screwdriver. There is no
need to loosen or remove the vent plug prior, during or after
use.
Cargo Net Installation
To install your cargo net, take
one of the loops located on
each corner of the net and slip
the loop through the desired tie
down on the deck of your board.
After the loop has been pushed
through the tie down, pull it up
and around the button & pull it
snug. Repeat for all corners.
The cargo net is perfect for
stowing your PFD or cargo.
1.
2.
1 2
3 4
4