Step 3 step 4 – ParkZone PKZ5080 User Manual

Page 4

Step 3

Step 4

Attaching the Wing

In order to attach the wing of your T-28D, please follow
these simple instructions:

1. Locate the included wing-securing screw.

2. Turn over the fuselage so you are looking at the

bottom. Do the same with the wing.

3. Connect the aileron leads to the pre-installed

Y-harness, noting proper orientation. Route the

Y-harness lead through the access hole in the bottom

of the fuselage.

4. Carefully align the two locator pins on the front of

the wing into the two small holes in the front of the

fuselage.

5. Slide the aileron leads inside the fuselage so that

they will not become pinched in between the wing

and the fuselage when securing the wing.

6. Slide the bottom of the leading edge of the wing into

the fuselage as shown, making certain it is perfectly

centered. This must be done correctly in order to

allow the screw to thread into the fuselage. Once you

are certain the wing is centered, tighten the screw to

secure the wing.

7. The wing is correctly installed when no gap exists

between the wing and fillet.

8. Gently pull up on the rear of the canopy hatch to

remove and set aside.

9. Plug the Y-harness lead into one of the AIL ports of

the Spektrum AR500 receiver.

Installing the Landing Gear

1. Install the main landing gear by inserting it into the

locator hole in the wing. Swivel the landing gear

toward the retaining clips and gently snap into place.

2. Insert the nose gear into the steering assembly

on the underside of the cowl with the flat spot

facing forward.

3. Align the retaining screw with the flat spot on the

cowl. The retaining screw should be visible through

the front of the cowl.

4. Using a Phillips screwdriver, tighten the retaining

screw. The retaining screw should be accessible

through the front of the cowl, however, you may

choose to remove the cowl for easier access.

5. Reposition the T-28D so that it is resting on the

landing gear.