ParkZone PKZ4675 - Manual (Page 3)

5 6
Attaching the Wing
In order to attach the wing of your Corsair PNP, please
follow these simple instructions:
1. Locate the wing securing screw (3mm x 30mm) in
the box.
2. Remove the canopy hatch by gently pulling up on
the back of the hatch and set it aside. Removing
the hatch will aid in routing the aileron leads from
the wing into the fuselage.
3. Turn over the fuselage so you are looking at the
bottom. Do the same with the wing.
4. Carefully align the two locator pins on the back of
the wing into the two small holes in the back of the
fuselage.
5. Route the aileron leads through the access hole in
the bottom of the fuselage.
6. Slide the aileron leads inside the fuselage so that
they will not become pinched in between the wing
and the fuselage when securing the wing.
7. Slide the leading edge of the wing into the fuselage
as shown, making certain it is perfectly centered.
This must be done correctly in order to allow the
screw to thread into the fuselage. Once you are
certain the wing is centered, tighten the screw to
secure the wing.
8. Connect the aileron leads to the included
Y-harness, noting proper orientation.
9. Replace the canopy by aligning the pins on the
front of the hatch with the fuselage. The magnet at
the rear of the hatch will ensure it is secure.
Step 3
Installing the Landing Gear
Install the main landing gear by inserting the wire into
the locator hole in the wing. Swivel the landing gear
toward the retaining clips and gently snap into place.
Installing Landing Skids (Optional)
Two landing gear skids have been included with the F4U
Corsair PNP should you choose to fly without the
landing gear. To install, simply apply the skids over
the landing gear mounts and secure with the included
screws. The rear edge of the skids can be secured to
the Z-Foam ™ using double-sided tape.
NOTE: The landing gear is directional. When properly
installed, the landing gear will rake forward to add
stability in landing. If the gear does not angle forward
when installed, simply reverse the landing gear.
Step 4