ParkZone PKZ4600 - Manual (Page 3)

5 6
Attaching the Wing
In order to attach the wing of your Corsair, please
follow these simple instructions:
1. Locate the wing securing screw (3mm x 30mm) in
the box.
2. Remove the canopy hatch by gently pulling up on
the back of the hatch and set it aside. Removing
the hatch will aid in routing the aileron leads from
the wing into the fuselage.
3. Turn over the fuselage so you are looking at the
bottom. Do the same with the wing.
4. Carefully align the two locator pins on the back of
the wing into the two small holes in the back of the
fuselage.
5. Route the aileron leads through the access hole in
the bottom of the fuselage.
6. Slide the aileron leads inside the fuselage so that
they will not become pinched in between the wing
and the fuselage when securing the wing.
7. Slide the leading edge of the wing into the fuselage
as shown, making certain it is perfectly centered.
This must be done correctly in order to allow the
screw to thread into the fuselage. Once you are
certain the wing is centered, tighten the screw to
secure the wing.
8. Connect the aileron leads to the pre-installed
Y-harness, noting proper orientation. The servo
leads are polarized to fit one way.
9. Replace the canopy by aligning the pins on the
front of the hatch with the fuselage. The magnet at
the rear of the hatch will ensure it is secure.
Step 3
an audible beep that matches the cell count, and
then the red (charge) LED will begin to flash. Do
not adjust the current once the charger has begun
to charge.
Note: At times, the green LED may also flash during
the charging process, indicating that the charger is
balancing one or more of the cells at the same time
it is charging the battery pack. When this is occurring,
the red and green LEDs will both be flashing. It will
not always be necessary for the cells to be balanced.
6. When the battery pack is fully charged, you will
hear an audible beep for about 3 seconds, and the
green LED will be solid. Always unplug the battery
from the charger immediately upon completion.
Failure to do so could cause a fire.
3S Port
Step 2 cont.