ParkZone PKZ1700 - Manual (Page 9)

9
For your convenience, the ZX10 radio included with
your Spitfire Mk IIB has been pre-programmed for use
with the included battery (9-cell 10.8V Ni-MH). If you
plan on only flying with the included battery pack, no
changes will need to be made. Simply proceed through
the Boot-Up process and you’re ready to fly. Proceed to
the Teach-In process only if you plan to use an optional
battery, such as an (2000mAh +) 11.1V Li-Po. The
voltage cutoff must be changed to prevent damage to
your Li-Po battery.
Boot-Up
1. With the battery disconnected from the receiver,
and the transmitter turned on, move the throttle
slide to the idle position. Leave it in this position
and then connect the battery to the receiver.
2. Wait for 2 seconds, and the motor will give one
long tone to indicate the receiver is connected.
3. After the long tone, you will hear a series of short
tones to indicate the current cutoff setting.
1 beep = 5.6V (7-cell Ni-MH )
2 beep = 6.0V (2-cell Li-Po)
3 beep = 9.0V (3-cell Li-Po)
7 beep = 70% Smart Cut soft cutoff
4. The receiver has now armed the motor, and when
you move the slide upward, the motor will run.
Teach-In from the Tx:
1. With the battery disconnected from the receiver,
and the transmitter turned on, move the throttle
slide to full throttle position. Leave it in this posi-
tion and then connect the battery to the receiver.
2. Wait for 2 seconds, and you will hear one long
tone to indicate the receiver is connected.
3. You will next hear a series of short tones to indi-
cate the current cutoff setting.
1 beep = 5.6V (6–7-cell Ni-MH )
2 beep = 6.0V (8–9-cell Ni-MH, 2-cell Li-Po)
3 beep = 9.0V (3-cell Li-Po)
7 beep = 70% Smart Cut soft cutoff
4. Next, after indicating the current cutoff setting,
wait 6 seconds. There will be a long beep
indicating you have successfully entered the
programming mode.
5. Once you have entered the programming mode,
the programming menu will give the following
selections:
1 beep = menu item1 = 5.6V (6–7-cell Ni-MH )
2 beep = menu item2 = 6.0V (8–9-cell Ni-MH,
2-cell Li-Po)
3 beep = menu item3 = 9.0V (3-cell Li-Po)
7 beep = menu item4 = 70% Smart Cut soft
cutoff
There will be a 4-second pause between each
selection. To confirm a selection, move the throttle
slider to the center position during the pause.
You will then hear 4 short beeps indicating that a
successful selection has been made.
Note: If the slider is left in the full throttle position
and upon reaching selection 4, no selection has
been made, the programming menu will repeat.
You may also scroll through the menu in reverse by
moving the throttle slide to the full down position
during any 4-second pause.
6. Move the throttle slide to idle. The receiver has
now armed the motor, and when you move the
slide upward, the motor will run.
This Rx/ESC will only have one jumper installed.
With jumper installed, dual rates are activated.
Removing the jumper (not recommended) will deac-
tivate dual rates.
Step 14