Paraclipse Terminato User Manual
Page 2
Save these instructions
Page 2
Table of Contents
Mounting Locations
Page 3
Mounting Options
Page 4
Ultraviolet Lamp Insertion
Page 5
Cartridge Insertion
Page 6
Manual Paper Advance
Page 6
Cartridge Alarm
Page 7
Maintenance Page
8
IMPORTANT SAFETY INSTRUCTIONS
This symbol is intended to alert you of
the presence of dangerous voltage
within the unit’s enclosure that maybe
of sufficient magnitude to constitute a
risk of electric shock.
This symbol is intended to alert you
of the presence of important operat-
ing and maintenance instructions
accompanying the unit.
Caution! To reduce the risk of electric shock, observe the following:
1. Do not remove the motor enclosure. No user serviceable parts are inside.
2. This product is intended for use indoors only! Do not use where it may be ex-
posed to water or direct sunlight (including roofed but open porches).
3. Use only extension cords marked SPT-2, or equivalent. Its electrical rating must be at
least 120 V, 60 Hz, and 1 Amps. Use only extension cords which have plugs and re-
ceptacles which accept product’s plug.
4. Replace or repair damaged cords.
5. Don’t abuse cord. Never carry product by cord or yank it to disconnect it. Keep cord
from heat, oil, and sharp edges.
6. Disconnect the product from power supply when not in use, before serving, or
when changing bulbs.
7. Extension cords & devices for retaining an extension cord connection to the power
supply cord are available.
CAUTION! To avoid risk of contamination, observe the following: Dead insects are un-
sanitary. Use care in removing used cartridge.
72955-5-6-2014
Paraclipse ™ Terminator
Page 7
CARTRIDGE ALARM
Cartridge Alarm
The Paraclipse ™ Terminator has a design feature
unique audible beep when it is time to replace the
cartridge.
The alarm is triggered when the paper no longer
covers the hole in the top of the paper holder plate
(fig. 8). An electronic light sensor recognizes this
and begins to emit a high pitched beep.
Testing:
To test the operation of the alarm follow these
steps:
1. Lower the cartridge door.
2. Carefully remove the cartridge. The alarm
should emit an audible beeping.
3. Stop the alarm by installing a fresh cartridge.
Note: If new cartridge is not available for installation,
unplug the unit to shut off the alarm until a genuine Para-
clipse replacement cartridge is available.
72955-5-6-2014
Fig. 8
Cartridge Alarm Sensor Hole