OPTI-UPS SS20K33 - Manual (Page 4)

- 4-
2‐ Safety warnings
For the user’s own safety, the safety of data and this product
read the following safety instructions carefully before using
the unit!
‐ This system has been designed to provide all the necessary safety conditions needed
to protect electronic office equipment including information systems. In case of any questions,
refer to your authorized technical service representative.
‐ In order to avoid any damage to the equipment, it is advised to transport it in its own packing.
‐ In the event of sudden temperature changes such as from cold to the normal working temperature,
mist can form inside the AVR. It is absolutely essential that the AVR be dry before switching it on.
Due to this reason wait for at least 2 hours before operating it.
‐ Once dry, make sure you observe all the conditions in the environment section of the technical
specifications table, before introducing it into the circuit.
‐ When installing the AVR it is necessary to use a connection cable of suitable diameter. The point to
be noted here is that the neutral and the earthing connections should be done in the proper way.
‐ Place all the cables in a proper place so that they are not stepped on or get caught into peoples feet.
Before connecting the AVR to the circuit make sure you carefully read all the instructions and
warnings in the“Montage and Operating Procedures“ section of this manual.
‐ Don’t drop any foreign materials (like clips, nails etc...) into the equipment.
‐ In emergencies (damage to the cabin, front panel, or mains connections,splashing of liquid dropping
of any foreign materials into the equipment) switch‐off the AVR, pull out the plug and inform the
authorized service center.
‐ The AVR can only be repaired by the authorized technical service personnel. Any attempt to open
and to repair by the user on his own could prove to be dangerous.
‐ Do not connect any consumer loads to the AVR, which exceed its power range.
‐ Read the instructions carefully in the “The Operation Procedures of Maintenance By Pass Switch” &
“Cleaning” section when cleaning the AVR.
‐ Leave at least a distance of 45 cm between the AVR and the walls in order to maintain adequate
air‐flow .