Instructions for setup, Morpho 2p – NEMO Equipment MORPHO 2 User Manual

Page 9

Connect Pump

Connect the Nemoid™ foot pump to the airbeam valves through
the access zippers. There will be an audible click when the pump
is connected properly.

Stake Corners

Secure the corner anchors by pounding the stakes into the
ground with a rock or hard object. If the ground is too hard,
trap the stakes under a rock or another heavy object.

Inflate Airbeams

To use the Nemoid™ foot pump, make sure the Dump-Check™
Valve is open. Step on the pump body repeatedly until it becomes
difficult to compress.

Tension

Proper tension in your tent shell ensures maximum water shedding
and wind resistance. Once the airbeams are inflated, pull firmly on
the adjustable corner anchors. Add guy-lines for additional strength.

Locate Valves

Remember to leave no trace. Before leaving your campsite take a thorough look
around making sure you have not left anything behind, out of place, or damaged.

To contact NEMO Customer Service

Email: [email protected]

Phone: 800-997-9301

MORPHO 2P

™

INSTRUCTIONS FOR SETUP

Find the airbeam access zippers near base of tent. The airbeam
valves will be directly inside the tent, behind the access zippers.