beautypg.com

NEMO Equipment TENSH User Manual

Tenshi, Overview set up, Take down

background image

©2006 NEMO Equipment, Inc.

*Patents Pending

TENSHI™

OVERVIEW

SET UP

To take Tenshi™ down, first remove all gear (including the vestibule,

condensation curtain and RIF) and as much moisture as possible. Water

will add weight to your pack and can lead to mildew.

1

If the pole wraps are stuck to the poles, it may be necessary to detach

them before removing the poles. Pull the poles straight out. If the pole

sections have frozen together, simply warm them in your gloved hand

for a minute or two and they should separate easily.

2

Try to clean as much dirt and debris from your tent as possible before

packing it. This will help preserve the breathability of the tent fabrics

and reduce overall wear and tear.

3

With your foot on the accessory pocket of the stuff sack, stuff the tent

into the large mesh pocket.

4

Place the poles inside the pole pocket, and roll the stuff sack up

securing it with the compression straps. The Tenshi stuff sack also works

very well as a hanging drying bag. See the features section for more

information.

5

Remember to leave no trace even in winter. Before leaving your

campsite take a thorough look around making sure you have not left

anything behind, out of place, or damaged.

6

TAKE DOWN

1

2

3

6

4

1. Removable Condensation Curtain

2. Waterproof Zipper for Vestibule Attachment

3. Internally Deployable Strutted Vents

4. Pressure Porting™

5. Guy-out Point

6. Replaceable Anchors

7. Triangulated Guy-out Points

8. Sleep Tight Anchor Transfer™ (STAT™) System

9. Rear Window

10. Hypalon® Reinforced Corner Pockets

11. Front Door Tie-backs

11. Snow Skirt

12. PU Weather Checking Window

13. Vestibule Door Tie-backs

14. Removable Insulated Floor (RIF™)

www.nemoequipment.com

NEMO EQUIPMENT

100 Factory Street, Nashua, NH 03060

Phone/Fax: 1-800-997-9301/ 603-881-9358

E-mail: [email protected]

Lay out the contents of Tenshi™ and make sure that you received your

tent and all of the following items: vestibule, condensation curtain, stuff

sack, 2 straight poles, vestibule pole, 8 stakes, guy lines, Seamgrip® with

nozzle, and pole repair sleeve.

Seam sealing adds strength and waterproofness to the tent. It needs at

least 24 hours to cure before using. See Care and Field Repair section for

more information.

Begin the setup of your tent by staking it out. This will help prevent the

tent from blowing away. The corners of the tent are reinforced with

Hypalon® to receive the ends of the poles. If applicable, slide the RIF into

Tenshi™ with the shiny sil-nylon side down and the orange corner up.

Place poles through the corner grommets.

To set up the optional vestibule, insert the pre-bent pole into the

vestibule pole sleeve. Place each pole tip in the grommet at the end of

the vestibule and front corners of Tenshi. Zip the vestibule to the tent.

Stake out the corners of the vestibule.

With both poles secured in the Hypalon® corners, use the Velcro wraps

to secure them along the inside of the tent shell.

5

To use the Condensation Curtain, match the Velcro on the curtain to the

Velcro on the inside of Tenshi™.

9

14

1

2

3

4

5

6

7

8

10

11

13

12

11

Integrated Pump and Airbeam

Tenshi™

5

4

2

1

3

6

6

5

3

4