Mossberg 935 Magnu - Manual (Page 7)

5
Figure 4
The bolt is always under spring pressure. When the bolt release is
pushed with the bolt locked rearward, the bolt is driven forward toward
the muzzle with considerable force. Do not have fingers or other objects
in the ejection port or near the operating handle.
Visually and physically inspect the chamber and bore of the barrel to
make certain it is free of any obstructions, excessive oil or grease. If you
are unable to remove any obstruction, bring the firearm to a qualified
gunsmith or send it to a factory authorized Product Service Center.
Obstructions of any kind can result in damage to the firearm and/or serious
personal injury to you or those around you when the firearm is fired.
TO CLOSE THE ACTION
Keep fingers clear of the operating handle and the ejection port when
closing the action. (Figure 4)
With the safety button fully rearward in the “ON” (SAFE) position, and the muz-
zle pointed in a safe direction, press the bolt release until the action releases
(Figure 4).
TO REMOVE THE MAGAZINE PLUG (NON SPX MODELS)
Be sure the firearm is unloaded by visually and physically checking
the chamber, elevator, and magazine tube. Make certain that the safety but-
ton is fully rearward in the “ON” (SAFE) position before performing any
assembly or disassembly procedure.
Unscrew and remove the magazine cap (Figure 9). Grasp the barrel and forearm to
prevent them from sliding forward. Do not place your hand over the muzzle at any
time. Point the muzzle downward and shake the firearm in an up and down motion
until the wooden dowel falls through the opening at the end of the magazine tube.
122276 1/19/12 2:37 PM Page 5