Mighty Mule FM700 - Manual (Page 27)

23
The four DIP switches on the control board match the opener with the type of gate on which it is
installed. For example, gates may pull-to-open or push-to-open. Prior to packaging, the Mighty Mule
Gate Opener
® control board was configured for single swing gates that pull-to-open (open into the
property). If your gate type matches this configuration, you DO NOT need to adjust the DIP switches;
proceed to the Potentiometers section on the next page.
NOTE: To change the DIP switch settings, you must turn the
control box power switch OFF; move the switch; then turn the
power back ON. Use a small screwdriver to move the switches.
PULL/PUSH: Set to PULL for swing gates that pull-to-open
[factory setting]; PUSH for swing gates that push-to-open (see
Push to Open Installation on pages 29-30).
NOTE: The direction a gate opens is determined by standing
inside the property and facing toward the gate.
SNGL/DUAL: Set to SNGL for a single gate leaf [factory
setting]; DUAL not applicable.
SEQ1: Not applicable (the factory setting is OFF).
SEQ2: Not applicable (the factory setting is OFF).
CONTROL BOARD SETTINGS
DIP switches
1234 ON
OBSTRUCT
SENS.
PULL/PUSH
SEQ1
SNGL/DUAL
SEQ2
LEARN
DIP switches
MIN MAX
RED
BLK
ORG BLU
GRN
CLS EDG
OPN EDG
RED
GRN
ORG BLU WHT
BLK
ORG
BLU GRN
CLS EDG
OPN EDG
LEARN
AUTOCLOSE
INERTIA
STATUS
PULL/PUSH
SNGL/DUAL
SEQ1
SEQ2
MIN
MAX
MIN
MAX
OFF
60
120
BATT +
–
OBSTRUCT
SENS.
RCVR
R B
G
ALARM
SECOND OPERATOR
FIRST OPERATOR
POWER IN
18VAC SOLAR
~ ~ – +
ACCESSORY
PWR. SW.