Magnepan CCR - Manual (Page 3)

4 Amplification
The CCR is a 3 ohm speaker and should be used with high current amplifiers
that are stable with low impedances. Some receivers are capable of driving low
impedances, but usually separate amplifiers are built to higher standards and
are recommended for use with the CCR.
5 Hookup
The CCR employs a unique, high-current connector. To install speaker cable,
simply strip approximately 1/4-inch of insulation from the speaker cable end,
insert the cable and tighten the set screw. Cables terminated with banana plugs
or pins may also be used. For cable terminated with spade lugs, spade lug
adapters are available from your Magneplanar dealer.
Connect the output of a high pass crossover (such as the Magneplanar XO-2)
to the input of the CCR (observing correct polarity). If the CCR is connected
directly to the center channel amplifier, the processor must be set on "small"
center channel speaker. (See Bass Management and Processor Settings section
below for correct settings of the processor.)
6 Installation and Placement
The CCR can be mounted in or on a cabinet or on credenza or shelf. The CCR
is a "small" speaker. (Three felt pads are included to prevent marring of the
bottom surface.) However, a Magneplanar CC Speaker Stand is available for
use with the CCR for use as a full-range, free-standing speaker. The CC
Speaker Stand has a built-in Magneplanar bass driver that utilizes the same
DiPlanar bass technology as the MG 20.1. If the CC Speaker Stand is not used,
some form of adjustable bass management is necessary (See Bass Management
and Processor Settings section below.)
Like all Magneplanars, the CCR is a dipole speaker. We recommend a
minimum of 12 inches clearance, measuring from the back of the CCR to the
surface behind the CCR. Damping material behind the CCR will help tame
unwanted resonances.
Revision—1-19–2015 Page of 3 12