Magnepan MMC 2 - Manual

MMC 2 INSTALLATION INSTRUCTION MANUAL
TABLE OF CONTENTS:
A. SELECTION OF SPEAKER LOCATION
B. PAINTING SPEAKER FRAMES
C. WALL PREPARATION
D. TOP FRAME INSTALLATION
E. ATTACHING BOTTOM FRAME TO SPEAKER
F. BOTTOM FRAME ATTACHMENT TO WALL
G. FINAL SPEAKER INSTALLATION
H. CAUTIONS
I. HOOKUP
J. SPEAKER ANGLE ADJUSTMENT
K. PHASING
L. BASS MANAGEMENT AND PROCESSOR SETTINGS
M. TWEETER LEVEL CONTROL
With a little experience, one person can install an MMC 2. However, for the first time, it is
recommended that an assistant help with steps D and E of the installation.
A.
SELECTION OF SPEAKER LOCATION
Before a permanent installation is begun, we highly recommend purchasing the $30 pair Disposable Speaker
Stand Kit to determine if the selected location gives the desired audio performance for the MMC 2s before the first
holes are drilled. These mobile wall stands allow the speakers to be easily moved around the room until a
permanent position is located. A set of mounting brackets are included with the MMC 2 speaker panels for
placement of the speaker panels on the Disposable Speaker Stands.
Because the MMC 2 can used for any channel in a home theater or music system (including as a center channel),
and because rooms conditions vary greatly, specific and detailed instructions are not practical. However, there are
general guidelines to follow.
Avoid corners. Choose a placement that will position the MMC 2 as far from a corner as possible - preferably
more than 3 or 4 feet and the further, the better. We want you to be a satisfied customer and this is a critical issue
for good sound. This is especially important for the front channels. Rear channels play a lesser role and more
liberties can be taken with the rear channels.
Choose a placement that will allow the bottom of the MMC 2 to be approximately 26 inches from the floor for proper
high frequency dispersion when you are sitting or standing.
To help determine the front of the MMC 2, the quasi ribbon foil can be seen through the fabric on the front of the
speaker. The speakers should be mounted so that the front of the speakers are on axis with the listener.
CAUTION- Using a level, check to see if the walls are within building code for plumb (vertical to a level floor). If the
walls are too far out of plumb, the speakers may not open or close.
B.
PAINTING SPEAKER FRAMES
Many customers will want to paint the top and bottom molding to match their decor. The top and bottom frames can
be ordered with a primer coat. We recommend Krylon spray can paint.
1. Mask off hardware in the speaker frames to prevent paint from fouling mechanical parts. Using a very fine
steel wool or sandpaper, lightly sand the primer surface to remove any possible contaminants from oily
fingers, etc.
2. Spray 4 or 5 light coats, allowing drying time to prevent runs in the paint and for a smooth finish. Sand with
fine 600 sandpaper between coats for an extra-smooth finish.
3. Spray a coat of Krylon clear coat (gloss or satin) to protect the finish.
4. Install the speaker trim in the edge of the speaker with a rubber mallet. (Masking tape over the trim will help