Ccr ribbon tweeter installation – Magnepan CCR User Manual
Page 11
![background image](/manuals/739227/11/background.png)
CCR Ribbon Tweeter Installation
If the CCR is shipped by ground transportation, the ribbon will be installed in
the CCR. The tweeter will be removed from the speaker only in the event of an
air shipment.
1. Remove 4 screws attaching terminal plate.
2. Remove screws holding rear panel
3. The CCR ribbon tweeter has a white dot at one end of the frame for
determining polarity. Install the ribbon so the end with the white dot can
be attached to the brown wire.
4. Install screws holding the tweeter frame. The tweeter magnets are very
powerful. Use caution to keep magnetic objects from being pulled into the
magnets.
5. Connect the wires to the terminals at both ends of the tweeter.
6. Reinstall the back panel and terminal plate.
Revision—1-19–2015
Page of
11
12