Luxul XBR-4400 - Manual (Page 7)

Simply Connected
© 2015 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
7
Verifying Connectivity
After automatic configuration of the TCP/IP parameters, the ping command can be
used to check connectivity between the XBR-4400 and the client device.
Windows Devices:
1. Select Start >> Run input cmd in the Run line then press enter.
2. At the newly opened command interface enter the following command: ping
192.168.0.1 and press enter. If connected properly, the system should report back a
result as follows: packets sent=4, packets received=4, packets lost=0. This means
the device is connected with a valid IP address.
Login
Parameter: Default Value
Default IP address: 192.168.0.1
Default user name: admin
Default password: admin
Login to the router with the following steps:
1. Plug an Ethernet cable into any of the four LAN ports of the router
2. Plug the other end into the Ethernet port of your computer
3. Power on the router
4. Check to see that the IP address of the computer is within this network segment:
192.168.0.xxx (“xxx” ranges 2~254). For example, 192.168.0.100.
5. Open the Web browser, and enter 192.168.0.1. The router login window appears,
as shown below.
6. Enter the user name and password (default user name and default password
are both set as “admin”), and then click “OK” to login to the router configuration
window.
ADVANCED SETTINGS
For login and advanced settings information go to luxul.com
WARNINGS AND SAFETY INFORMATION
„ Read all installation instructions and site survey reports, and verify correct equipment installation
before connecting the XBR-4400 to its power source.
„ Verify that the electrical circuits have appropriate grounding and overload protection.
„ Attach only approved power cords to the device.