Desa SH-5710 - Manual (Page 2)

2 598-1163-01
INSTALLATION
For easy installation, select an existing light with a wall
switch for replacement.
W
IRE THE
L
IGHT
C
ONTROL
.
❒
Turn power off at the fuse or circuit breaker.
❒ Remove the existing light fixture.
❒ Install the mounting strap as shown using two screws
that fit your junction box.
❒ The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger can
be threaded through the hole in the center of the
cover plate. The small end then goes into one of the
slots on the mounting strap.
❒ Route the Light Control’s wires through the large
gasket holes.
❒ Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.
M
OUNT THE
L
IGHT
C
ONTROL
.
❒
Align the Light Control cover plate and cover plate
gasket. Secure with the mounting bolt.
❒
Push the Rubber Plug firmly into place.
❒
If a wet location junction box was not used, caulk the
wall plate mounting surface with silicone weather
sealant.
Lock Nut
To avoid water damage
and electrical shock,
keep lamp holders 30
°
below horizontal.
For eave mount only:
❒ Swing the sensor head towards the clamp
screw joint.
If the sensor pops out of the ball joint, loosen the clamp
screw and push the sensor back into the ball joint.
Tighten the clamp screw when done.
❒
Then rotate the sensor head clockwise 180
°
so the
controls face down.
Controls
Wall Mount Eave Mount
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
123456789012345678
123456789012345678
Controls
Controls
Clamp Screw
❒
Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180
°
from the factory setting. When screwing in the
lamps, do not overtighten.
❒
Install the lamp covers. Align the tabs on the lamp
covers with the holes on the lamp holders. Gently
press lamp covers until the tabs snap into the holes
on the lamp holders.
Keep lamps at least 1"
(2.5 cm) from the sen-
sor. Do not allow the
lamps to block the lens.
Lens
Push Rubber Plug
Firmly into Place.
Holes for Lamp
Cover Tabs
White to
White Black to
Black
Junction box ground wire to
green ground screw on fixture.
Gasket
Mounting
Strap
Mounting
Bolt
Rubber
Plug