beautypg.com

Desa SH-5710 User Manual

Motion sensor light control, Operation, Model sh-5710

background image

© 2004 DESA Specialty Products™

598-1163-01

Requirements

• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must be

wired through a switch.

Some codes require installation by a

qualified electrician.

• This product is intended for use with the enclosed

gasket and with a junction box marked for use in wet
locations.

• Note: This product is not recommended for use where

the outside temperature is below -10

°

F.

Model SH-5710

Light Control

Sensor

Cover Plate

Lamp Holders

Features

• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
• Additional energy savings with compact fluorescent

bulbs.

Motion Sensor
Light Control

Plastic Hanger

Rubber Plug

Gasket

6 Screws

(3 sizes included)

Mounting Strap

Mounting Bolt

2 Compact

Fluorescent Bulbs

2 Wire

Connectors

This package includes:

OPERATION

* resets to Auto Mode at dawn.

MANUAL MODE

ON-TIME

10 5 1 TEST

10 5 1 TEST

ON-TIME

TEST

... back on.

AUTO

1 Second OFF

then...

Put the ON-TIME switch in the 1, 5, or
10 minute position. Note: Although
the 1 minute mode can be used, the 5
or 10 minute mode is recommended
for best operation and performance
when using compact fluorescent bulbs.

Put the ON-TIME switch on the bottom
of the sensor in the TEST position.

Manual mode only works at night
because daylight returns the sensor
to AUTO.

Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.

Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.

Move ON-TIME Switch

to 1, 5, or 10 minutes

Mode Switching Summary

Flip light switch

off for one second

then back on*

MANUAL MODE

AUTO

TEST

* If you get confused while switching modes, turn the

power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.

Note: When first turned on wait about 1

1

/

2

minutes for

the circuitry to calibrate.

Mode:

On-Time:

Works:

Day

Night

Test

5 Sec

x

x

Auto

1, 5, 10 min.

x

Manual

Until Dawn*

x