Lingenfelter L710111005 Trailblazer SS & SSR E85 High Flow Fuel Pump Upgrade Kit v1.5 - Manual (Page 7)

18. Feed the fuel line and the fuel pump wires up
through the mounting sleeve on the module.
19. Slide the fuel pump up into position. You may
need to turn the pump to index the sock so that
it will fit into the bucket.
20. Remove the tape from the Jet pump and
fittings.
22. Slide the remaining Oetiker clamp over the
fuel line and slide it down out of the way.
21. Install the bucket onto the module making
sure that it is fully seated and that all of the
retaining tabs are latched.
23. Using a heat gun and pair of needle nose pliers
expand the end of the fuel line and install onto
the barbed fitting on top of the fuel filter.
WARNING: Make sure not to overheat or
otherwise damage the fuel line, as doing so could
cause the fuel line to leak.
Page 6 of 9
24. Using an Oetiker clamp installation tool, or a
diagonal cutter, clamp the fuel line onto the
barbed fitting.