Lingenfelter L460190108 Lingenfelter CTAP-001 Clutch & Throttle Activation Position Switch v1.7 - Manual (Page 7)

Page
LNC-2000, LNC-2001 and LNC-003 related installation notes:
• For connecting the CTAP-001 to the LNC-2000, LNC-2001 or LNC-003, either a 12v or a ground activation method
can be used. All of the wiring diagrams supplied with the LNC-2000, LNC-2001 and LNC-003 show using a 12v
activation trigger.
• This is done because 12v activation problems are usually easier to trace and diagnose than ground activation
problems. If a wire has missing insulation and touches to ground you may not be able to easily tell. If a 12v wire
shorts to ground it will usually blow a fuse or some other similar indicator of a problem.
• If activating the LNC with the CTAP-001 via 12v activation, connect the orange +12v normally off activation output
wire from the CTAP-001 to the yellow +12v activation input wire on the LNC.
• If activating the LNC with the CTAP-001 via ground activation, connect the yellow normally off ground activation wire
from the CTAP-001 to the green ground activation wire on the LNC.
• Do not use both methods at the same time on the LNC. You must use one or the other, not both.
• The CTAP-001 outputs not being used for the LNC can be used to activate other devices since all CTAP-001 outputs
can be used at the same time.
• Once you have connected the CTAP-001 to the position sensor signal wire, mount the CTAP-001 in a location that will
not impact the travel of any of the pedals.
6.