Lab.gruppen fP2600 - Manual (Page 6)

6. Fan grill filters
Two grilles with foam filters are located on the front panel to prevent dust from entering the amplifier. For
easy cleaning of the filters the grilles are removable by simply pulling them off. The foam filters should
always be used.
7. Power switch
Turns mains power on or off. (See page
10 and 14 )
QKP= oЙ~к=m~åÉä=
Figure 2: Rear panel
1. Output / Speaker connector
The Speakon connector from Neutrik® may be unfamiliar to some users. A full description can be found
in the “Connections” section. (See page
13 )
2. Minimum load selector (MLS™) switch
This switch is used to select the maximum output power. (See page
8 )
3. Clip limiter switch
Turns the clip limiter on or off. (See page
14 )
4. Input signal XLR.
Neutrik® Combojack features also ¼” TRS phone jacks. (Pin 2 is “hot”, see page
12 )
5. Link output
XLR male connector connected in parallel to the female for linking the channel to another input.
6. Gain switch channel B
Three of the switches in the DIP switch selects the maximum gain of the channel to be either 20, 23, 26,
29, 32, 36, 39 or 41dB. (See page
6 )
7. Link/Bridge switch
Two of the switches in the DIP switch are used for Link and Bridge operation. (See page
6 )
8. Gain switch channel A
Three of the switches in the DIP switch selects the maximum gain of the channel to be either 20, 23, 26,
29, 32, 36, 39 or 41dB. (See page
6 )
9. AC power cable
i~ÄKÖêìééÉå== = = = = ====================== ======================== R
rëÉê=j~ем~д===Сm=OSMMLNNR======sÉêëáçå=MKV========OMMPJMOJOP=