Konig Electronic Wireless alarm system - Manual (Page 4)

4
9 times, and the emergency voice message can be repeated up to 9 times. To program phone numbers,
follow the procedures below.
Function Key Description Note
Enter program mode by MPIN [PROG] [MPIN]
Select program phone numbers [1]
Select phone memory [1] to [5]
Enter the phone number, then [Arm] [Phone Number] [Arm] Phone number
Enter redial count, then [Arm] [1] to [9] [Arm]
Enter message repeat count, then [Arm] [1] to [9] [Arm]
Note: Do not program police, or fire station phone numbers into any of the phone memories.
Operation - Alarm
Arm
You should arm the Control Panel if you are the last person to leave
the house. To arm, press [Arm], Control Panel will beep for
45 seconds, this is called the exit delay. You must leave the house
within 45 seconds.
Note: Control Panel can only be armed when no sensor is triggered.
Triggered sensors must be deactivated in order to successfully arm
the system.
Disarm
If you are the first one to enter the house with the Control Panel armed, you must disarm it within the
entry delay period of 30 seconds, otherwise the alarm will sound. To disarm, enter the 4-digit password,
either the master password or secondary password.
Default Master Password: 1234
Default Secondary Password: 0000
Note: It is strongly recommended that you change both master and secondary passwords from the
default value. Please refer to the User’s Instructions for details.
Panic
During an emergency, any user can activate the alarm immediately by
pressing the red panic button. When the panic button is pressed, 2
things will happen:
1. Alarm will sound;
2. Control Panel will call the pre-programmed phone numbers for
assistance.