HITEC Focus Heli 5 FM - Manual (Page 6)

The trim lever on each control stick is uised to correct (trim out) flight
characteristics. After the initial test flight note the positionts of the control surfaces
that required trim. Next center trim levers, turn off the reciever radio. Now adjust
the control clevises of the surfaces that required trim so that the surfaces are in the
same position before the trim levers were re-centered. Turn on the receiver radio
and recheck the dcontrol surface to ensure that all the corrections were applied in the
correct direction.
B. Servo reverese
The Focus Heli-5 F.M. transmitter is equipped with servo reversing on all 6
channels (including Pitch servo).
(Note: Leaving the reverse switch in the middle will cause the radio to work
erratically so please make sure that the switches are all pushed to the furthest end.)
C. Aileron amd elevator
adjustable travel volume
(A.T.V.)
This function adjusts the servo left
and right throws on aileron and
elevator servo by twisting the trimmer
in the front panel with the provided small
screwdriver. The rate setting range
is 30% to 110%
D. Hovering pitch trim & pitch
trim & pitch curve high & low
The Focus Heli-5 transmitter
provides adjustment of pitch trim &
high & low collective points.
5
fig 5
fig 6
fig 7