Heath Consultants Aqua-Scop User Manual

Page 15

Figure 7 illustrates the Meter Readout Module, an accessory item with

AQUA-SCOPE® . The charger plug/jack system differs from the plugs

and jacks used with other AQUA-SCOPE® components to minimize

error. A rechargeable nine-volt battery, internal to the Meter Readout

Module, powers the instrument.

BATTERY TEST: The internal battery may be tested by depressing the

square button “Battery Test” switch shown in Figure 7 while observing

the Meter (the instrument must be turned “ON”). The Meter must read a

minimum of 0.7. If a lower reading is obtained, a complete recharge is

required.

Resonant Plate (part No. 2921326).

(Figure8)

General Specifications:

CONSTRUCTION:

1/8” steel, octagonal plate.

Approximately 6 1/2” diameter

maximum.

WEIGHT:

Approximately 2.5 Lbs. (1135 Grams).

The Resonant Plate shown upside down with the contact rod and thumbscrews

not assembled in Figure 8 is used to enhance water leak detection in unpaved

areas. The Ground Microphone rests on top of the Plate during use.