DYSON DC07 - Manual (Page 14)

Clearing blockages
Wand
Remove wand as shown on
page 11, and press the wand
release button to remove the
wand from the hose. Check
inside wand for blockages.
CAUTION
• Beware of sharp objects
when clearing blockages.
Hose
A Press the cyclone release catch
to remove the Clear bin TM
assembly from the machine.
B Press the lower hose release
button from the front of
machine and slide the hose
out from the rear, holding the
lower cord winder. Check
inside the hose for blockages.
Clearing blockages
CAUTION
• Unplug the machine from the
electrical outlet before starting
to look for blockages. Failure
to do so could result in
electric shock or personal
injury.
• If any part of the machine
becomes blocked it may
overheat and then stop
automatically shut off. Unplug
machine and leave to cool
down for at least 60 minutes
before clearing the blockage.
• Regularly wipe the soleplate
and wheels with a dry cloth
after vacuuming to clean off
any sand, dirt, or pebbles that
could damage delicate floors.
• Please note: clearing
blockages is not covered by
your machine’s limited
warranty.
• Refit all parts of the machine
before using it.
A
B
Dyson Helpline contact us at 1-866-693-9766 7 days a week 14
Tools
Check that the tools are clear of
blockages.
16852_DCO7_OP_MAN_US.qxd 5/7/07 14:00 Page 14 (Cyan plate) (Magenta (PANTONE plate) (Yellow plate) (Black plate) Red 032 C plate)
10:39:28 2007-07-06 C_16852_DCO7_OP_MAN_US_4c1s.pdf