Hanna Instruments HI 8064 - Manual (Page 6)

11 10
• CALIBRATION & MAINTENANCE SOLUTIONS
• CHEMICAL TEST KITS
• CHLORINE METERS
• CONDUCTIVITY/TDS METERS
• DISSOLVED OXYGEN METERS
• HYGROMETERS
• ION SPECIFIC METERS
• MAGNETIC STIRRERS
• Na/NaCl METERS
• pH/ORP/Na ELECTRODES
• PROBES (DO, µS/cm, RH, T, TDS)
• PUMPS
• REAGENTS
• SOFTWARE
• THERMOMETERS
• TITRATORS
• TRANSMITTERS
• TURBIDITY METERS
• Wide Range of Accessories
Most Hanna meters are available in the following formats:
• BENCH-TOP METERS
• POCKET-SIZE METERS
• PORTABLE METERS
• PRINTING/LOGGING METERS
• PROCESS METERS (Panel- and Wall-mounted)
• METERS FOR FOOD INDUSTRY
For additional information, contact your dealer or
the nearest Hanna Customer Service Center.
You can also e-mail us at [email protected]
HANNA PRODUCTS WARRANTY
All Hanna Instruments meters are warranted
for two years against defects in workman-
ship and materials when used for their in-
tended purpose and maintained according to
the instructions. The probes are warranted
for a period of six months.
Damages due to accident, misuse, tamper-
ing or lack of prescribed maintenance are not
covered. This warranty is limited to repair or
replacement free of charge.
If service is required, contact the dealer from
whom you purchased the instrument. If under
warranty, report the model number, date of
purchase, serial number and the nature of
the failure. If the repair is not covered by the
warranty, you will be notified of the charge
for repair or replacement. If the instrument is
to be returned to Hanna Instruments, obtain
a Return Goods Authorization from the Cus-
tomer Service Department first and then send
it with shipment cost prepaid. When shipping
any instrument, make sure it is properly pack-
aged for complete protection.
All rights are reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Hanna Instruments reserves the right to modify
the design, construction and appearance of its
products without advance notice.