Dixon ZTR 7525 - Manual (Page 24)

24
OPERATION INSTRUCTIONS
In order to achieve optimum cutting performance,
please read and follow the tips listed below. Additional
information can be found in the Troubleshooting Guide
on Page 36-37.
CAUTION
Be sure that deflector is properly installed
on the discharge chute.
1. Set engine speed control to the wide open or full
setting.
2. Do Not Attempt To Cut Grass When It Is Wet.
Wet grass will clog the underside of the deck
and discharge area.
3. If the grass is tall, place the mower deck cut height
lever in the top or second notch. “Initially” overlap
cutting swaths instead of taking a full swath with
each pass. Some applications may require a
second cutting.
4. Keep The Underside Of The Mower Deck Clean.
Frequent removal of dried grass and dirt will allow
the clippings to discharge correctly. (Never attempt
to clean or service deck with engine running and/or
PTO engaged. This safety precaution must be
observed or serious injury could occur.)
5. Maintain Sharp Blade(s) Throughout The Cutting
Season.