Specifications, 7500 series – Dixon ZTR 7525 User Manual
Page 13
13
SPECIFICATIONS
7500 Series
CHASSIS:
Folded sheet metal and rectangular tube
BODY:
Folded sheet metal
SEAT:
Designed for operator comfort with padded back and arm rests.
Seat is adjustable fore and aft.
MOWER DECK: Deck is made of 10 GA fabricated welded construction with 7 GA
reinforcement plates. Three blades combine for a 60" cut width.
Cut height approximately 1.5" to 5" via 10 position lift handle.
BLADE DRIVE:
Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDP
10A pump and a HydroGear HGM-15E hydraulic motor.
ENGINE:
25HP Kohler Command, 4-Cycle, V-Configuration, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head, and
Crankcase with Cast Iron Liners, Full Pressure Lubrication/Full
Flow Filter, Pulse-type Fuel Pump, Fixed Jet Carburetor w/
Smart-Choke, Electronic Ignition, In-Line Fuel Filter, Dual Element
Air Cleaner.
STARTING
Electric by key switch operation with safety interlocks on parking
SYSTEM:
brake and blade drive clutch.
TIRES:
Front 13-5.00x6
Rear 23-9.50x12
RECOMMENDED Front
12 lbs.
TIRE PRESSURE: Rear
12 lbs.
CAPACITIES:
Fuel - 11 gallons (approx)
Hydrostat oil system - 4 qt with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 31
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS:
Width 69-1/2"
Height 43"
Length 81
Weight 916 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE